Gtco QuikRuler III - Users Guide Manual do Utilizador descarregar pdf (Página 30)

QuikRuler III 30

Messages

QuikRuler III displays a variety of messages as you use its functions. Most of the messages

are indicative of normal operation, such as prompts that instruct you how to perform the

next step in a process. Other messages can signal a problem.

Message

Meaning

**No Digitizer**

QuikRuler III is not attached to the digitizer. You must

attach it before you can proceed. See instructions for

Connecting the Components.

**Memory Failure**

The power on test detected a memory failure. QuikRuler

III will attempt to continue normally with all operations, if

you click the stylus tip or cursor anywhere on the digitizer

surface.

**Bad Ref Point**

This message will appear during a Relocate Menu

operation when an incorrect lower left or lower right

reference point is entered. Make sure that the entire

QuikRuler Menu is within the digitizer’s measuring area.

Repeat the Relocate Menu operation when this message

appears.

**Menu Off Tablet**

This message will appear during a Relocate Menu

operation when the QuikRuler Menu is not positioned

entirely within the digitizer’s measuring area. Move the

menu and repeat the Relocate Menu operation when this

message appears.

**Number Too Big**

The number on line 2 of the display is too large for

QuikRuler III. Try changing units to reduce the number

size when this message appears.

If you receive any of these messages and the above suggestions do not correct the

problem, contact the GTCO CalComp by Turning Technologies Technical Support Team.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 41 42

Sem comentários

Gtco QuikRuler III - Users Guide Manual do Utilizador Página 30