Gtco QuikRuler III - Users Guide Manual do Utilizador descarregar pdf (Página 10)

QuikRuler III 10

QuikRuler Menu Location

When QuikRuler III is shipped to you, it is programmed to expect the QuikRuler Menu to be

located in the lower left corner of the digitizer’s active area.

Relocating the Menu at Start-Up

When you start QuikRuler III, the below message appears for five seconds.

If you do not want the QuikRuler Menu to be positioned in the lower left corner of the

digitizer, this is the time to relocate it.

1. Position the menu where you prefer to have it located and tape it down. The entire

menu must be within the digitizer’s active measuring area.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 41 42

Sem comentários

Gtco QuikRuler III - Users Guide Manual do Utilizador Página 10