Gtco Roll-Up III - Users Guide Manual do Utilizador descarregar pdf (Página 9)

Roll-Up III 9

Using the SuperSet Menu

The SuperSet Menu is the row of buttons printed in the lower left and upper right corners

of the digitizer.

The SuperSet Menu makes it possible to configure the Roll-Up III so that it sends the

appropriate information for a serial connection to the software being used on your

computer (see Table 1 section of this manual for an extensive list of digitizer software

applications and their codes). It is used to prepare the digitizer to receive specific, detailed

custom configuration information from the Custom Configuration Menu for some serial

installations. In addition, the SuperSet Menu can be used for both serial and USB

connection configurations, to set and change the digitizer orientation, and to turn the

digitizer alarm off and on. Use your stylus or cursor to click on the menu buttons to make

your selections.

The menu button initiates Select Mode. Two-digit numeric codes are entered after

Select Mode is activated. Most software supports Wintab using the TabletWorks drivers,

whose SuperSet Code is on the SuperSet Menu. The Roll-Up III comes from

the factory with the SuperSet Code pre-configured.

NOTE: Select Mode will not work with the USB interface. USB talks to Wintab drivers

exclusively.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 47 48

Sem comentários

Gtco Roll-Up III - Users Guide Manual do Utilizador Página 9