Gtco AccuTab VI - Users Guide Manual do Utilizador descarregar pdf (Página 15)

AccuTab VI 15

2. Move your cursor around in the Active Area. If there is a break in the grid or the

cursor is out of prox, the digitizer will beep.

3. Click the button again to end the test.

NOTE: The following is relevant only for RS-232 serial installations. USB does not require

configuration.

Configuring Your AccuTab VI for Specific Applications

To configure AccuTab VI for use with specific applications:

1. In Table 1, find the application program you will be using with your AccuTab VI.

Note the corresponding AccuSet Code.

 If the application program is not listed in Table 1, find the configuration

settings in Table 2 that your application program requires and use the

corresponding AccuSet Code.

 If an appropriate AccuSet Code is not listed in Table 2, use the Tablet

Configuration Utilities to configure your AccuTab VI.

2. On the AccuSet Menu, select the button and then click on the two digits of the

AccuSet Code indicated for the application. You will hear four short tones after a

successful menu configuration.

Example: Configuring for a Specific Application

To configure AccuTab VI to operate with Autodesk’s AutoCAD application, you would:

1. Find the entry for AutoCAD in Table 1. The AccuSet Code is

2. Click on the button on the AccuSet Menu. You will hear one short tone,

indicating the digitizer is in Select Mode.

3. Select from the AccuSet Menu. You will hear one short tone. This enters the

first digit of the AccuSet Code for AutoCAD.

4. Click on the button on the AccuSet Menu. This enters the second digit of the

AccuSet Code for AutoCAD.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 45 46

Sem comentários

Gtco AccuTab VI - Users Guide Manual do Utilizador Página 15